360 intake removal
-
- Sweptline.ORG Member
- Posts: 122
- Joined: Mon Dec 08, 2008 6:21 pm
- City: MO
360 intake removal
Any tips on removing a stubborn intake on a 360 motor?
-
- Sweptline.ORG Pioneer
- Posts: 975
- Joined: Thu Sep 25, 2008 7:50 pm
- City: Brooklyn
- State: NY
- Location: New York City
- Contact:
Re: 360 intake removal
Are you sure you have all the bolts out?
Usually you can pry on the front and back, gently, under the ends of the manifold. Most times there is enough space to get a smallish prybar in there.
Usually you can pry on the front and back, gently, under the ends of the manifold. Most times there is enough space to get a smallish prybar in there.
- soopernaut
- Sweptline.ORG Pioneer
- Posts: 8931
- Joined: Wed Dec 31, 1969 6:00 pm
- Location: Des Moines,IA
Re: 360 intake removal
I had a IH 345 that I had to really pry on to get the manifold off but it eventually came off.
- MoJoe
- Sweptline.ORG Member
- Posts: 12
- Joined: Sat May 14, 2011 7:50 am
- City: Holland
- State: MI
- Location: West Michigan
Re: 360 intake removal
BE VERY CAREFUL NOT to pry against the timing chain cover!!!
It is aluminum and very thin on the top and will break, dont ask how I know this!
I pry between the head and the intake right in the front after I triple check to make sure there are no bolts left.
good luck
Joe
It is aluminum and very thin on the top and will break, dont ask how I know this!
I pry between the head and the intake right in the front after I triple check to make sure there are no bolts left.
good luck
Joe
1970 D100 Shortbox
1967 Plymouth Barracuda
1968 Plymouth Barracuda
1969 Dodge Charger
1967 Plymouth Barracuda
1968 Plymouth Barracuda
1969 Dodge Charger